Nature2 Spa Cartridge natural mineral sanitizer for use in the filter core.
Lasts for 4 months.
Use with a very low chlorine residual.
The Nature2 Cartridge purifies spa water using the natural sanitizing effect of silver. The cartridge fits into the centre of most spa filter cartridges where it will sit happily for 4 months, fighting a continuous battle against bacteria, viruses and algae.
Nature2 is compatible with the Jacuzzi ProClear system and is also a direct replacement for the Hot Spring FreshWater Ag+ Continuous Silver Ion Purifier,
How to use...
- Start with a clean hot tub and fresh water
- Balance the water to within the following range:
|pH ||7.2 - 7.6|
|Calcium Hardness ||200 - 400 ppm|
|Total Alkalinity ||80-120 ppm|
- Install the Nature 2 Spa cartridge into the filter core. When installed, the cartridge must be at least 1" (2.5 cm) above the bottom of the filter to prevent blocking the water flow. Please see Nature2 Owners Manual for more information
- Shock the spa water with approximately 1.5 tablespoons (25 grams) of chlorine granules per 220 gallons / 1000 litres of water according to the instructions on the label. Wait until the chlorine residual has dropped to below 5ppm before entering the water.
- After each use: add 1 heaped teaspoon of chlorine granules according to the instructions on the label.
- Weekly: check the water balance and adjust as necessary.
- Every 4 months: change the water and repeat the start-up process with a new Nature2 cartridge.
The Nature2 cartridge is suitable for use in hot tubs up to 416 gallons / 1892 litres.
Do not use with Bromine sanitation.