Replacement Hot Tub Cover High Density Foam Insert

£215.00
In stock
SKU
INS1

A single replacement cover insert with a choice of thickness.

  • Rigid, polystyrene, heavy-density (25kg/cubic metre), EPS foam in-fill board to provide exceptional heat retention.
  • 500g/125micron, heat-sealed Polythene surrounds the foam to provide a robust waterproof seal.
  • Aluminium 50mm x 20mm 'C' channel along the spine to provide added rigidity.
  • 4" - 2" (102mm - 51mm) or 3.5" -2.0” (95mm - 51mm) taper to guarantee adequate rain run-off and prevent sagging, with the option of a 5" - 3" (125mm - 76mm) or a 6" - 4" (150mm - 102mm) taper for a small additional charge.

Please configure the size of each insert using the form below. If you require two inserts you will need to purchase two.

Delivery currently approximately 7 - 10 working days from order

NB The price is per insert ie for half of the cover.

MEASURING NOTES

You should use your existing inserts to measure from. Inserts will be made to the exact size you specify so so please ensure that you will be able to fit them into your existing cover skin.

Shape: The standard cover shape options are shown in the diagrams above, but if you would like a different shape please contact us to discuss. Refer to the diagram to see which dimensions to enter for the lengths A, BC and D (not all measurements are required for every shape).

Size of Inserts: This option is available for inserts with a maximum dimensions on either side less than 2.4m.  For larger inserts please contact us for a quotation.

How to Measure the Radius of Corners (D): Refer to the diagram above and, using two straight edges, extend two imaginary lines from the break in the curve of the corner (point X) until they meet at an imaginary point Y. Determine the measurement from point X to point Y. This will be the radius of your corner.  If you have any doubt then specifying a slightly larger radius than the radius of the cover skin will ensure that the inserts fit the skin at the corners.

Please note that we are unable to manufacture inserts for irregular shaped covers.

  • Rigid, polystyrene, heavy-density (25kg/cubic metre), EPS foam in-fill board to provide exceptional heat retention.
  • 500g/125micron, heat-sealed Polythene surrounds the foam to provide a robust waterproof seal.
  • Aluminium 50mm x 20mm 'C' channel along the spine to provide added rigidity.
  • 4" - 2" (102mm - 51mm) or 3.5" -2.0” (95mm - 51mm) taper to guarantee adequate rain run-off and prevent sagging, with the option of a 5" - 3" (125mm - 76mm) or a 6" - 4" (150mm - 102mm) taper for a small additional charge.
  • Please configure the size of each insert using the form below. If you require two inserts you will need to purchase two.

    Delivery currently approximately 7 - 10 working days from order

    " data-url="https://www.hottubsuk.co.uk/replacement-hot-tub-cover-foam-inserts" data-image-url="https://www.hottubsuk.co.uk/replacement-hot-tub-cover-foam-inserts" data-price="215" data-currency="" data-per_page ="4" >
    OTHER PRODUCTS YOU MIGHT LIKE
    © 2014/24 Surespa Ltd